Table of Contents
Advertisement
Available languages
Available languages
EN
Wear heavy gloves or wind cloth around the impeller
when you touch the impeller.
1. Remove the screws(1) from each side plate.
2. Remove and discard the old scraper.
3. Install the new scraper.
4. Put in the mounting screw(2) and spacers and
tighten them.
8.3
REPLACE THE IMPELLER
6
5
Use only approved replacement scrapers.
1. Remove the screws(1) and side wear pad(2) of left
and right side covers.
2. Remove the nut(3).
3. Remove the belt(4).
4. Remove the the large pulley(5) with a socket wrench
(23 mm).
5. Pull the axle(6) and remove the old impeller.
6. Install the new impeller.
7. Reinstall the components.
8.4
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person of an approved service
center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the
machine.
WARNING
3
4
2
1
WARNING
English
9
TROUBLESHOOTING
Problem
The handle is
not in position.
The machine
does not start.
The motor is on,
but the impeller
does not turn.
A thin layer of
snow stays be-
hind.
* If you cannot find the solution to these problems,
please go to the service center.
10
TECHNICAL DATA
Voltage
No load speed
Working width
Wheels
Weight (without battery
pack)
11
LIMITED WARRANTY
YEAR/ANS/AÑOS
TOOL WARRANTY
GARANTIE DE
L'OUTIL
HERRAMIENTA
Greenworks hereby warranties this product, to the
original purchaser with proof of purchase, for a period of
four (4) years against defects in materials, parts or
workmanship. Greenworks, at its own discretion will
16
Possible cause
Solution
The bolts are not
Adjust the height
engaged correct-
of the handle
ly.
and make sure
that the knobs
and bolts are
aligned correctly.
The switch is de-
Have the switch
fective.
replaced by an
authorized serv-
ice center.
The extension
Connect the plug
cord is not con-
on the machine
nected to the
to the extension
plug.
cord.
The extension
Plug the exten-
cord is not con-
sion cord into a
nected to the
live 120 V AC,
power source.
60 Hz outlet.
The belt is dam-
Replace the belt.
aged.
The scraper is
Replace the
damaged.
scraper.
120 V, 60 Hz, 13 A
2500 RPM
20" (50.8 cm)
7" (17.8 cm)
32.4 lbs (14.7 kg)
Advertisement
Chapters
Table of Contents
