Bluetooth Controller; Controller Connection - Geneinno T1 Pro User Manual

4. Bluetooth Controller

a. Switch On:
Flip the left switch to "On", hold the Home button (2 seconds) till LED1
and LED2 are flashing, controller is power;
b. Controller connection:
After the controller enters the connection mode, open the menu on the
right side of the APP homepage, choose "Bluetooth Controller ", click to
search Bluetooth controller , it can find the Bluetooth controller
(GENEINNO-XXXX), click "Connect", after the connection is successful,
the controller LED1/2 will always be on;
c. Switch Off:
Flip the left switch to "Off", controller will power off. If the controller is
not connected for 3 minutes after power on, the controller will
automatically shut down; after 5 minutes without any operation since
Bluetooth controller connected, the controller will automatically shut
down.
d. Recharge:
Pull down the right joystick of the Bluetooth controller , when LED1/2
become off, the controller is in low battery state and needs recharge,
LED1/2 are always on when charging. When LED3/4 are flashing, LED3/4
are always on, the controller is fully charged.
L：Record
L2：Shot
Direction
control
Stick:
up/down
left/right
© 2020-2022 GENEINNO All Rights Reserved.
Dive up/down
X：increase gear
Y：reduce gear
A：Confirm
B：Quit
6