Table of Contents
Advertisement
Lateral Thruster
Installation
① Unscrew the sealing metal cover of the extension port of the intelligent
underwater robot counterclockwise. Match the slot of thruster to the
slide rail in the bottom of the host, slide the thruster according to
direction indicated by the arrow.
② Fix by screws when it is in right position.
③ Insert the connector of the thruster into the extension port . Tighten it
clockwise.
Note: The connector has an anti-reversal insertion design, please pay
attention when inserting, please do not rotate when inserting, to avoid
damage to the pin and its internal structure.
Using
l Install and connect the Lateral Thruster to underwater robot first, and
then power on the robot. Use a tablet or smart phone to connect, and
enter the control page in the Geneinno APP.
l Operate the right joystick to control the horizontal movement, the
left and right direction is the movement direction of the T1.
①
© 2020-2022 GENEINNO All Rights Reserved.
③
②
8
Advertisement
Table of Contents
