Table of Contents
Advertisement
VI. Maintenance
1.
After each use in sea water, please soak the underwater robot in fresh
water for at least 1 hour and run it in fresh water for 10 minutes
2.
Keep each port and connector dry and clean, always tighten the
protective cover if necessary. Salt and humidity will corrode the
conductors of the connectors. Please wash with running water, and use
absorbent cotton or handkerchief to wipe off the excess water.
3.
After each use, check whether the propeller is entangled with seaweed,
fishing line and other foreign objects. Start the fuselage and check
whether the propeller can rotate normally.
4.
Rinse the sand and gravel regularly, soak the underwater robot in fresh
water for at least one hour, and shake the underwater robot upside
down to drain the sand and gravel from the drainage holes until clear
water flows out.
5.
Check the buoyancy cable regularly. If it is found to be worn or broken,
please replace it in time.
6.
Please store the underwater robot in a dry environment with a
temperature range of 5°C to 25°C.
7.
If you need to store the machine for a long time, please keep the battery
level between 50%-60%. Please keep the battery level between 50% and
60% if you charge it every 90 days. If the storage time is more than 90
days, you must recharge it. If you don't charge it in time, it may cause
the battery to be over-discharged and damaged. This kind of damage is
unrecoverable.
After-sale service
More information please check in Geneinno APP Help selection.
If you need other after sales support or technical issue, please contact
support@geneinno.com
https://www.geneinno.com/support
This manual is subject to update without prior notice
© 2020-2022 GENEINNO All Rights Reserved.
or check our website "Service & Support",
13
Advertisement
Table of Contents
