Bluetooth Controller - Geneinno TITAN User Manual

Bluetooth controller

1. Connecting：
A: Start up: Turn the left button to the on position, press the HOME for 2 seconds until
the LED1 and LED2 flickering, the controller turns on.
B: Connect: When the controller is turned on, the light flickers, the controller is in the
connecting mode. Open the APP on your device, open the right menu bar, open
Bluetooth controller, tap to search the controller, you can find the BLE device named
GENEINNO-XXXX, tap to connect; when Bluetooth controller connected, the LED1/2 light
stays on.
C. Turn off: Turn the left button to the off position, the controller turns off. When it
turns on for 3 minutes without connect the device, the controller will turn off
automatically; when the Bluetooth is connected for 3 minutes with out operation, the
controller will turn off automatically.
D. Connect position confirm： When it controller is connected successfully via
Bluetooth, open the GeneROV APP, there will be the controller icon indication in the APP
operation interface.
2. Bluetooth controller keys：
A: Confirm for menu and pages, switch for menu of turn on/off；
B: Back for menu and pages, cancel；
X: Gear reduce by one, doesn't work when it's in the max third gear；
Y: Gear increase by one, doesn't work when it's in the min first gear.;
R: Light down by one, LED out when it's 0, doesn't work when it reach it min.
R2: Light up by one, doesn't work when it reach the max.
R3(Press the right gear vertically): Turn on/off the lock of depth.
L: Start/pause recording ；
L3: (Press the left gear vertically): Turn on/off the lock of direction；
Stick R: Pop for more page information(Home page), selection move to the right or
current value increase by one(home page)，
Copyright © 2018 GENEINNO All Rights Reserved.
L2: shot, start/pause burst；