Fuses - Toro Reelmaster 3555 Operator's Manual

Note:
Do not fill the cells above the bottom of
the split ring inside each cell.
5. Install the filler caps with the vents pointing to
the rear (toward the fuel tank).
6. Clean the top of the battery by washing it
periodically with a brush dipped in ammonia
or bicarbonate of soda solution. Flush the top
surface with water after cleaning.
Important:
Do not remove the filler caps
while cleaning.
7. Check the battery cable clamps and battery
posts for corrosion. If corrosion occurs, perform
the following:
A. Disconnect the negative (–) battery cable.
B. Disconnect the positive (+) battery cable.
C. Clean the clamps and posts separately.
D. Connect the positive (+) battery cable.
E. Connect the negative (–) battery cable.
F. Coat the clamps and terminals with battery
terminal protector.
8. Check that the battery cable clamps are tight on
the battery posts.
9. Install the battery cover.
Note:
Store the machine where the temperature is
cooler rather than warmer to prevent the battery from
discharging more rapidly.

Fuses

Servicing the Fuse Block
1. Lift the cover from the control arm
1. Control-arm cover
2. Fuse block
2. Locate the open fuse in the fuse holder or fuse
block (Figure
3. Replace the fuse with the same type and
amperage fuse.
4. Assemble the cover onto the control arm
68).
Servicing the Telematics Fuse
1. Remove the battery cover;
Cover (page 41).
2. Remove the cap from the in-line fuse holder
(Figure 69).
48
(Figure
Figure 68
3. Right side of the machine
68).
Removing the Battery
68).
g352264
(Figure