Toro Reelmaster 3555 Operator's Manual page 50

WARNING
If the machine is not supported
adequately, it may accidentally fall,
injuring anyone under the machine.
Raise a front wheel and the rear wheel off
the ground; otherwise, the machine will
move during adjustment.
3. Loosen the locknut on the traction adjustment
cam (Figure 70).
Figure 70
1. Traction adjustment cam
WARNING
The engine must be running so that
you can make a final adjustment of
the traction adjustment cam. Contact
with hot or moving parts can result in
personal injury.
Keep your hands, feet, face, and other
body parts away from the muffler, other
hot parts of the engine, and rotating
parts.
4. Start the engine and rotate the cam hex in both
directions to determine the mid position of the
neutral span.
5. Tighten the locknut securing the adjustment.
6. Shut off the engine.
7. Remove the support blocks and lower the
machine to the shop floor. Test drive the
g352331
2. Locknut
machine to ensure that it does not move when
the traction pedal is in neutral.
50