Silvercrest SED 3.7 A1 Operation And Safety Notes page 12

3) Press the travel lock
GB
the desired speed level:
― Level 1: for sensitive areas (armpits and bikini line)
― Level 2: for legs
4) Hold the skin tight with one hand.
5) Place the epilator perpendicular to the skin and, without exerting
any pressure, move it against the direction of the hair growth.
Thereby, the side with the speed regulator 6 must face towards
you. Do not make back and forth or circular movements.
Always start anew and pass over the body part to be epilated
several times, so that all of the hair is removed.
NOTICE
► It may be that the hair grows back after a few days. The
reason for this is that these hairs were too short to be
removed during the last epilation session.
6) When you are fi nished with the treatment, place the speed switch
6 to "0".
7) Clean the epilator head
and Care".
8) Replace the protective cap
ensure that the elongated depression on the protective cap lies
on the elongated elevation on the front of the appliance.
Otherwise, the cap does not hold correctly.
10
5 and slide the speed switch 6 upwards to
2 as described in the section "Cleaning
1 on the epilator head 2. Thereby,
SED 3.7 A1