Toto Neorest NX Instruction Manual page 31

W h at to D o?
Long Periods of Disuse
H ow to d rain th e w ater ( C ontinu ed )
Drain the pipe.
6
① Remove the cover on the left side of the main
unit and water filter drain valve.
• Insert the flat-head screwdriver firmly in the hook.
(May cause damage.)
• Loosen the water filter drain valve with a flat-head
screwdriver and then pull it.
② After draining the water, install the water filter
drain valve.
• Insert the water filter drain valve and use a flat-
head screwdriver to tighten it securely.
Pull out the water drain lever.
7
・ W ater comes out from around the wand
(about 20 seconds).
Release your hand to return the water drain
8
lever to its original position.
9
Install the cover.
■ I f w ater m ay g et f roz e n
• Add antifreeze solution in the water in the bowl to prevent freezing.
(The antifreeze solution should not be flushed out. Collect it before using the toilet and dispose of it.)
■ T o u s e th e th is prod u c t ag ain
• The water needs to be resupplied. (Page 61)
60
Cover
Hook
Flat-head
screwdriver
Water filter drain valve
Water drain lever
Push until a "click"
sound is heard.
R es u ppl y ing th e W ater
Remove the shutoff valve cover, and then
1
open the shutoff valve.
◦ Check that water is not leaking from a pipe or the top
unit.
2
Install the shutoff valve cover.
Switch the breaker on the distribution board to ON.
3
• The "Power" LED lights up.
①Discharge water from the wand.
4
(1) Press and hold pressure on the seat sensor with your
hand or arm (see page 9 for details).
(2) Press "Rear cleansing"button to discharge water
from the wand.
• Catch the water in a paper cup or other receptacle.
(3) Press "Stopping" button.
②•
Press "Full flush" button on the remote control.
◦ The toilet flushes while the tank fills with water. The LED on the main display flashes. It stays lit after the tank
becomes full (about 80 seconds max.).
* You cannot flush the toilet until water supply is complete. Never operate the toilet while the tank is filling with
water.
■I f th e rem aining w ater h as f roz e n and no w ater c om es ou t
◦Heat the inside of the bathroom, and warm the water supply hose and shutoff valve using a cloth soaked in warm
water.
After the bowl unit fills with water, press ("Full flush" button) again.
5
Shutoff valve
cover
Opening / closing
tool (accessory)
or flat-head
screwdriver
Paper cup
Seat sensor
(Built-in)
61