Toto Neorest NX Instruction Manual page 27

If the water does not flow due to a power outage
W h at to D o?
If the water does not flow due to a power outage (when water failure hasn't occurred)
■ You can flush the toilet with the hand lever (for flushing in case of power outage).
* Pulling the hand lever does not flush the toilet when the power is supplied.
When testing the operation, switch the breaker on the distribution board to OFF.
Remove the rear cover of the main unit while
1
pushing outward on the portion indicated by
the ● in the figure.
Rear cover
Pull the hand lever to where it stops.
2
(about 30 seconds).
・The water surface in the bowl rises.
N o w ater in th e b ow l
overflows.
52
Hand lever
(For flushing in case of power outage)
K eep
pu l l ing
If water does not flow during a power outage (when water failure hasn't occurred) (Continued)
When the beep sound is made and water
3
supply stops, release the hand lever and
return it to its original position.
・The toilet flushes.
* You cannot flush the toilet for about 60 seconds after
flushing it or releasing the hand lever halfway.
Wait at least about 60 seconds and then flush the toilet
again.
Install the rear cover of the main unit.
4
・Insert the cover tabs securely.
(May cause damage to the rear cover.)
Attention!
◦When power is restored, be sure to perform a full flush. (To prevent waste from remaining in the discharge pipe.)
* You can flush the toilet with a bucket. (Page 56)
R el eas e
Rear cover tabs
53