Table of Contents
Advertisement
O
PERATING
Menu Navigation
To select any of the pre-set functions, press the MENU button until the desired function is shown on
the display. Select the function by pressing the ENTER button and the display will blink. Use the
DOWN and UP button to change the settings. Once the required setting has been selected, press the
ENTER button to activate it. If you don not press the ENTER button, it will automatically return to the
main functions without any change after idling 8 seconds. To go back to the functions without any
change press the MENU button. The main functions are shown below:
MENU
Upon powering up the unit, you will notice that it will display a fixture ID. After this initial power-up
sequence, if the fixture receives no DMX signal, it will enter into a stand alone mode. Be sure to
power up your DMX controller device before the lighting fixture to avoid unwanted auto mode
operation.
ST-200X User Manual
I
NSTRUCTIONS
DMX-512 Address Setting
no
No to Master Mode
8LSH
Show Mode "8 Light Show"
IdSP
Display Inverse
Addr
NASt
Yes to Master Mode
SHNd
Show Mode "4 Light Show"
IdSP
Display Normal
test
Self test
FhrS
Fixture hours
rSeT
Figure 2 - Display Panel Diagram
Reset
7
1 ~ 512
YeS
4LSH
dSPI
Revision: 2004-11-02/11:00
Advertisement
Table of Contents
