Setup; Ac Power; Mounting - Chauvet Q-Wash LED User Manual

3. S
ETUP

AC Power

Warning! Verify that the voltage select switch on your unit matches the line voltage applied.
Damage to your fixture may result if the line voltage applied does not match the
voltage indicated on the voltage selector switch. All fixtures must be connected to
circuits with a suitable Earth Ground.
• To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture's specifications chart.
• A fixture's listed current rating is its average current draw under normal conditions.
• All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
• Before applying power to a fixture, check that the source voltage matches the fixture's
requirement, and that the fuse is the value specified for the operating voltage (110V operation =
2A 125V/250V fast blow; 230V operation = 1A 250V fast blow).
• All fixtures must be connected to circuits with a suitable Earth Ground.
P ow e r C a b l e C o n f i g u r a t i o n
C
ABLE
B
ROWN
B
LUE
Y
ELLOW

Mounting

O r i e n t a t i o n
This fixture can be mounted on a truss using a clamp in any position or against a flat surface using
the brackets provided.
R i g g i n g
The fixture includes two brackets with ¼ turn locks for attaching a
standard truss mounting hanging clamp. You must supply your own
clamp and make sure the clamp is capable of supporting the weight
of this fixture. You can order C-clamps from any CHAUVET
dealer or distributor.
1.
2.
3.
4.
5.
Q-Wash LED User Manual
Pin International
Live L
Neutral N
/G Earth EG (Ground)
REEN
Block access below the work area and use suitable and
stable platform when installing or servicing fixture.
Align the clamp screw with the center hole on the yoke
and tighten.
Verify the structure can hold 10 times the weight of all to-
be installed fixtures.
Adjust the angle on the yoke arm as necessary.
Always use a safety cable or chain as a secondary
source of attachment. The safety cable must hold 10
times the weight of the fixture. If safety cable attachment
point is provided that is permanently affixed to the
surface or body of the fixture, use that instead of looping
through a hanging yoke/arm.
Screw Color
Yellow or
Brass
Silver
Green
7
Hanging Clamp
Revised: 2006-12-11 11:35:30