Important Safety Information; Fuse Replacement - Chauvet Q-Wash LED User Manual

Important Safety Information

This product is designed for professional use. It is not intended for use in a household environment.
This product presents risks of lethal or severe injury due to fire and heat, electric shock, ultraviolet
radiation, lamp explosion, and injury from falls. Read this manual before installing or powering the
fixture, follow the safety precautions listed below and observe all warnings in this manual and on the
fixture. If you have any questions about how to operate the fixture safely, please contact CHAUVET.
P r o t e c t i o n a g a i n s t E l e c t r i c S h o c k
•
Always disconnect from AC power source before servicing or replacing lamp or fuse.
•
All Class I fixtures must be connected to circuits with a suitable Earth Ground.
•
To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no
flammable materials close to the unit while operating.
•
Make sure power cord is never crimped or damaged.
•
Never disconnect power cord by pulling or tugging on the cord.
P r o t e c t i o n a g a i n s t F i r e & B u r n s
•
Always make sure that you are connecting to the proper voltage and that the line voltage you are
connecting to is not higher than that stated on decal or rear panel of the fixture.
•
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent
surfaces. Be sure that no ventilation slots are blocked.
•
Maintain a minimum distance of 1 meter (3.28 feet) from combustible materials.
•
Maximum ambient temperature (Ta) is: 35°C (95°F). Do not operate fixture at temperatures
higher than this.
P r o t e c t i o n a g a i n s t I n j u r y t o p e r s o n s
•
Secure fixture to fastening device using a safety chain.
•
Do not open fixture for a minimum of 15 minutes after switching off.
•
In the event of serious operating problem, stop using the unit immediately. Never try to repair the
unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center. Always use the same type
spare parts.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service,
please contact CHAUVET.

Fuse Replacement

With a flat head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.
Q-Wash LED User Manual
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
4
Revised: 2006-12-11 11:35:30