Setting Up Admx Serial Data Link - Chauvet COLORado 3 User Manual

Setting up a DMX Serial Data Link
Connect the (male) 3 pin connector side
of the DMX cable to the output (female) 3
pin connector of the controller.
Connect the end of the cable coming from
the controller which will have a (female) 3
pin connector to the input connector of
the next fixture consisting of a (male) 3
pin connector.
Then, proceed to connect from the output
as stated above to the input of the
following fixture and so on.
CHAUVET Certified DMX Data Cables
Order Code
DMX1.5
DMX4.5
DMX10
COLORado™ 3 User Manual
Description
DMX Cable 1.5m/4.9ft
DMX Cable 4.5m/14.8ft
DMX Cable 10m/32.8ft
11
Universal DMX Controller
Continue the link
Setup
This drawing provides a
general illustration of the
DMX Input/Output panel
of a lighting fixture.
8/1/2007 10:30 AM