Cable Connectors; 3-Pin To 5-Pin Conversion Chart; Setting Up Admx Serial Data Link - Chauvet Vue VI User Manual

6-channel dmx-512 rotating led moonflower
Hide thumbs Also See for Vue VI:
Table of Contents

Advertisement

CAB LE C ONN ECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX connector configuration
INPUT
CAUTION
3-PIN TO 5- PIN CON VE
Note!
3 P
5 P
IN TO
Con
duc
tor
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Do not use
Do not use
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector sid
of the controller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connecto
to the input connec
3. Then, proceed to connect from the output as stated above to the input of the following fixture and
so on.
CHAUVET Certified DMX Data Cables
Order C
DMX1.5
DMX4.5
DMX10
Vue™ VI User Manual
COMMON
1
DMX +
3
2
-
DMX
Do not allow contact between the common and the fixture's chassis ground. Grounding the common
can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm meter to
verify correct polarity and to make sure the pins are not grounded or shorted to the shield or each othe
R SION CHAR T
If you use a controller with a 5
CHAUVET Model No: DMX5M
The chart below details a proper cable conversion:
C
C
IN
ONVERSION
HART
3 Pin Female (output)
Pin 1
Pin 2
Pin 3
tor of the next fixture consisting of a (male) 3 pin connector.
ode
Description
DMX Cable 1.5m/4.9ft
DMX Cable 4
.5m/14.8ft
DMX Cable 10m/32.8ft
8
1
3
2
1
OUTPUT
3
Termination reduces signal errors and
2
to avoid signal transmission problems
and interference, it is always
advisable to connect a DMX signal
terminator.
pin DMX output connector, you will need to use a 5 pin to 3 pin adapter.
, or DMX5F.
5 Pin Male (Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use
U
niversal DM
X Controller
e of the DMX cable to the output (female) 3 pin connector
Continue the link
Resistance 120
ohm 1/4w between
pin 2 (DMX -) and
pin 3 (DMX +) of
the last fixture.
r.
r
This drawing provides a
general illustration of the
DMX Input/Output panel of
a lighting fixture.
2007-12-12/17:23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents