Positioning; Temporary Positioning; Positioning In The Planned Location - treesse Muse Installation Manual

Transport and position
2

POSITIONING

TEMPORARY POSITIONING

The installation of the minipool should be done
immediately upon receipt.
In any case, once unpacked, if it is necessary to
temporarily place it on a surface awaiting the installation,
it will be necessary to place level concrete slabs having
a minimum thickness of 5 cm under the entire bottom
of the minipool.
Since the temporary base may shift, it is recommended
to leave the minipool in that position for the shortest
possible time.

POSITIONING IN THE PLANNED LOCATION

In case of installation above ground (freestanding),
place the minipool in the installation environment
(outdoor or indoor) and verify its perfect flatness, essential
for proper operation.
For a recessed installation, lower the minipool into the
prepared space.
If it was not possible to provide a technical
inspection port on all sides of the minipool, a
pneumatic lift is available (OPTIONAL - to be
requested from the Manufacturer) in order to simplify
future maintenance operations. It is recommended to
provide a removable inspection hatch "A" positioned on
the side where the minipool components are situated.
After positioning the minipool in its prepared space and
after having connected the lift, test it.
Do not leave the empty minipool in DIRECT
SUNLIGHT. The surface temperature could rise
above 80°C resulting in serious damage, including
cavitation and the deformation of the surface and
components. Damage caused by direct exposure to
sunlight is not covered by the warranty.
In such conditions place a cover (fixed or mobile) to
protect the minipool.
Muse - Maya - Wave
EN
Optional lift with removable inspection hatch "A"
positioned on the side where the components of the
minipool are situated.
7
minipool
80°C 80°C
176°F
176°F