Table of Contents
Advertisement
Transport and position
2
POSITIONING
TEMPORARY POSITIONING
The installation of the minipool should be done
immediately upon receipt.
In any case, once unpacked, if it is necessary to
temporarily place it on a surface awaiting the installation,
it will be necessary to place level concrete slabs having
a minimum thickness of 5 cm under the entire bottom of
the minipool.
Since the temporary base may shift, it is recommended
to leave the minipool in that position for the shortest
possible time.
POSITIONING IN THE PLANNED LOCATION
In case of installation above ground (freestanding),
place the minipool in the installation environment (out-
door or indoor) and verify its perfect flatness, essential
for proper operation.
For a recessed installation, lower the minipool into the
prepared space.
If it was not possible to provide a technical inspec-
tion port on all sides of the minipool, a pneu-
matic lift is available (OPTIONAL - to be request-
ed from the Manufacturer) in order to simplify future
maintenance operations. It is recommended to provide
a removable inspection hatch "A" positioned on the side
where the minipool components and connections are
situated.
After positioning the minipool in its prepared space and
after having connected the lift, test it.
Do not leave the empty minipool in DIRECT SUN-
LIGHT. The surface temperature could rise above
80°C resulting in serious damage, including cavi-
tation and the deformation of the surface and compo-
nents. Damage caused by direct exposure to sunlight is
not covered by the warranty.
In such conditions place a cover (fixed or mobile) to pro-
tect the minipool.
EN
minipool
Optional lift with removable inspection hatch "A" posi-
tioned on the side where the components of the minipool
are situated.
7
Phantom
80°C
176°F
Advertisement
Table of Contents
Need help?
Do you have a question about the Phantom PR1 and is the answer not in the manual?