wallas 3008 Manual page 3

Control Panel 3008 Installation
Control Panel 3008 cable connection can be assembled in surface mount or through hole.
Surface, cable visible
Install the assembly plate and mark places for the
screws. Pre-drill 3*1 mm holes for screws. Install the
wall plate.
Cut the cable opening in bottom of the panel.
Slide the panel in place top-down.
Remove the display protection tape.
Hole, cable hidden inside the wall
Install the assemply plate.
Drill 12 mm hole for the cable. Draw and check hole
place before drilling, it should not be visible when panel
is on its place.
Slide the panel in place top-down.
Remove the display protection tape.
Cable connection
Please note that cable connector release pin is as in
the picture, when connecting cable into panel. (Silent
click sound can be heard when cable is connected.)
Cable release
Press connector release clip (shown in the picture)
before pulling the cable off.
- 1 -