wallas 3008 Manual page 15

Operating Mode
Heater can be started
remotely in two modes:
Heating/Thermo Control:
Set a target room
temperature C°/F°
Ventilation: Blow fresh air
without heating
Prior to starting the heater,
choose mode by swiping
the screen to the 2nd page
and tap Change under
Operating Mode to set the
desired mode (Heating or
Ventilation).
Due to safety, heater
cannot be sarted remotely
in Manual Mode.
To switch between the
modes, turn the heater off
and start in the desired
mode.
Ignition
Press and hold the
Start/Stop Icon down for 2
seconds to start the heater.
Starting will appear on the
screen. Orange combustion
light will light up when the
burner flame has been
ignated and the combustion
has stabilized (approx. in 5
min). Heater will be fully
operational about 10 min
later.
Temperature
In Heating/Thermo Control
Mode the thermostat can
be set to a target room
temperature.
Press the Minus or Plus
Icons to adjust the
temperature to the desired
level.
- 13 -
Air Boost
Air Boost maximizes the air
volume for quick defrosting
and drying, but does not
change the set
temperature.
While the system is heating,
press the Air Boost Icon
until the orange Air Boost
light appears.
To go back to normal air
volume, press the Air
Boost Icon again. The light
will turn off.