wallas 3008 Operation Manual

OPERATION GUIDE
3 0 0 8 A D V A N C E D C O N T R O L P A N E L
Please Refer to Manual for Full Operation and Maintenance Instructions at wallas.com
1
2
Select
Button
5
Left Arrow
Right Arrow
Move cursor
left or up Move cursor
right or down
SET OPERATION MODE
Thermo Control Mode: Set a target temperature (C°/F°)
Manual Mode: Blow heat with 6 power levels (1-6).
Ventilation Mode: Blow fresh air without heating
Prior to starting the heater, choose mode by using
the Arrow Buttons (left or right) to move the
orange selection square to the Main Menu Bar,
press Select Button to activate the Main Menu Bar,
use Arrow Buttons to choose the desired mode and
press the Select Button to select. To switch
between modes, turn the heater off and start in the
desired mode.
V i k i n g S e r i e s , S p a r t a n S e r i e s
Digital Panel Legend
Main Menu Bar
1
3
4 4
6
7
(MAIN MENU BAR)
Target Temperature / Power
2
Level / Blower Speed
Room Temperature
3
Heater Status
4
Start/Stop Icon
5
Air Boost Icon
6
Info Bar
7
Manual Mode
Thermo Control Mode
Ventilation Mode
Settings
Temp Sensor
Device Info
Device Stats
Clear Lock
Temp Unit (C°/F°)
Connections
Altitude
Power On/Off
Combustion
Info
Lock
Heater power %
IGNITION
To start, use the Arrow Buttons
(left or right) to move the orange
selection square to the white
Start/Stop Icon and press the
Select Button. Confirm the
selection by holding the Select
Button down for 3 seconds (safety
feature). White icon turns orange.
Starting will appear on the screen.
The light orange combustion light
will light up when the burner flame
has been ignited and the
combustion has stabilized (in about
5 min). Heater will be fully
operational about 10 min later.
TEMPERATURE/POWER SETTING
In Thermo Control Mode, move
the selection square to the Target
Temperature and press the Select
Button. Press Arrow Buttons (left
or right) to set the desired target
temperature.
In Manual Mode, move the
selection square to the Power
Level and press the Select
Button. Use Arrow Buttons to
set the desired power level (1-6).