wallas 3008 Manual page 16

Ventilation
Ventilation mode blows
fresh air without heating
with 6 blower speeds.
Swipe the screen to the
2nd page and tap on
Change under Operating
Mode until you see
Ventilation. It is now set and
you can start the heater as
usual (see ignition).
WiFi Connection
Control panel can be connected to the internet with WiFi connection.
You can then operate your heater with the " Wallas Remote" application through the Internet.
Wifi connection is created through the Wallas Remote application. ( Local connection between application and Control
Panel must be available before setup)
The first time selecting Connect, the application will ask for SSID and Password. Application will share this information
with Control Panel.
NOTE! If you sell your heater or give it away, you need to clear WiFi settings. ( SSID="empty", password="empty") and
you should remove the Wallas application from your device.
Ventilation
Press and hold the
Start/Stop Icon down for 2
seconds to start the heater.
Press Minus or Plus icons
to set the desired power for
the fan (1-6).
To deactivate Ventilation
Mode turn the heater off.
Re-start in the desired
mode.
Pause
Pause Mode automatically
turns the heater off if the
temperature remains +2° (3
F°) above the set level for
1/2 hour due to local
ambient conditions.
If the heater is in Pause
Mode, Paused will appear
on the screen.
Pause Mode can be turned
off temporarily by slightly
increasing the target
temperature.
Heater will re-start heating
again automatically, if the
cabin temperature falls 2
degrees (3 F°) below the
set target temperature.
- 14 -
Shutdown
Press and hold the
Start/Stop Icon down for 2
seconds.
Stopping will appear and
the Start/Stop icon will turn
white indicating the unit is
off.
Note: The heating mode
that was used last upon
shutdown will be the same
mode when the heater is
turned on again.