Servicing The Tool; Maintenance Frequency; Cleaning; Spare Parts - Tools - Stanley NB08PT-18 Instruction Manual

E N G L I S H

6. SERVICING THE TOOL

6.1

MAINTENANCE FREQUENCY

Item
General Tool Inspection
Clean and lubricate the mandrel
Lubricate Spin pull head and Spin pull head case
Clean & grease Ball Screw and Thrust Bearing
*Recommend contacting authorized service centre
6.2

CLEANING

ALWAYS wear approved eye protection at all times when cleaning equipment
Tool Exterior
Keep the brushless motor exhaust vent openings (H) free from dust and dirt. If necessary, use a soft, moist
cloth to remove dust and dirt from the exhaust vents. Blow dirt and dust out of the main power tool housing
with dry air as often as dirt is seen collecting in and around the exhaust vents (H).
WARNING: Wear approved eye protection and approved dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool.
These chemicals may weaken the materials used in these parts. Use a cloth dampened only with water
and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.
Cleaning the mandrel (fig. 4 & 5)
•
Remove the battery (K) from the tool. (fig.3).
•
Loosen the nose housing nut (E). Remove the nose housing (D).
•
Clean the mandrel (A) by using a metal brush to remove metal powder or debris.
•
Lubricate by splaying a lubrication onto the thread and non-thread of the mandrel (A).
•
Screw the nose housing nut (E) onto Mast housing (T).
Lubricate the spin pull head and spin pull head case (fig. 5)
•
Remove the battery (K) from the tool. (fig.3).
•
Loosen the nose housing nut (E). Remove the nose housing (D).
• Lubricate by spraying a lubrication between Spin pull head (R) and Spin pull head case (Q) every
1,000 nuts.
•
Screw the nose housing nut (E) onto Mast housing (T).
Charger Cleaning Instructions
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning.
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush.
DO NOT use water or any cleaning solutions.
6.3 SPARE PARTS – TOOLS
For spare parts we refer you to the specific service manuals which you can find on our website at
http:// www.stanleyengineeredfastening.com/resource-center/document-library
20
Frequency
Daily
Every day
1,000 nuts
50,000 nuts*