S1 Dip Switch - Bosch Rexroth IndraControl VDP 16.3 Project Planning Manual

36/57
Interfaces
7.1.2

S1 DIP switch

Overview
Operating Modes
Bosch Rexroth AG R911323862_Edition 07
IndraControl VDP 16.3, VDP 40.3, VDP 60.3 Operator Dis‐
Name at Availability Connection type
the
housing
XSER Only at CDI interface, data
CDI
devices
XVID Only at CDI interface, image
CDI
devices
XUSBIN Only at USB2.0 connection to
CDI the control cabinet PC.
devices Length of 5 m max.
Only high-speed
USB2.0 cables may be
used (see
"Ordering information"
on page
XCDI+rx Only at CDI+ interface, image
CDI+ and data
devices
Tab. 7-1: Interfaces at IndraControl VDP 16.3 and IndraControl VDP 40.3
There is only a DIP switch at devices with a CDI interface. The
DIP switch is not available at devices with CDI+ interface.
Name at the Switch type
housing
S1/switch 1 DIP switch
S1/switch 2 DIP switch
Tab. 7-2: DIP switch at the VDP
Cable length max. 5 m between control cabinet PC and VDP
If the distance to the control cabinet PC does not exceed 5 m, the USB
connection to the VDP can be executed in the USB 2.0 mode (High Speed,
max. 480 Mb/s) by using an additional USB 2.0 cable. The S1 switch 2 must
be in the "OFF" position. If the cable is not used, the USB connection is
executed using USB 1.1. (max. data rate at full speed: 12 Mb/s).
Cable length max. 30 m between control cabinet PC and VDP (stand‐
ard USB mode)
The USB connection is executed in the USB1.1 mode. The S1 switch 2 must
be in the "OFF" position.
Connector
type, integrated
RJ45 socket
RJ45 socket
USB socket,
4-pin, type B
chapter 11
47)
USB socket,
4-pin, type B
Function
No function
OFF: Cable length to the control cabinet
PC < 30 m
ON: Cable length to control cabinet PC >
30 m
play
Mating
connector or
cable (from
outside)
RJ45 plug
RJ45 plug
USB plug,
4-pin, type B
USB plug,
4-pin, type B