Safety Instructions; Installation - Zanussi ZPCNA4K1 User Manual

Disconnect the appliance from the power supply before
•
carrying out any maintenance.
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.
The control panel must be connected to specified heating unit
•
with matching colours of connectors, to avoid possible hazard.
The means for disconnection must be incorporated in the fixed
•
wiring in accordance with the wiring rules.
WARNING: Ensure that the appliance is switched off before
•
replacing the lamp to avoid the possibility of electric shock.
WARNING: The appliance and its accessible parts become hot
•
during use. Care should be taken to avoid touching heating
elements.
Always use oven gloves to remove or put in accessories or
•
ovenware.
To remove the shelf supports first pull the front of the shelf
•
support and then the rear end away from the side walls. Install
the shelf supports in the opposite sequence.
Do not use a steam cleaner to clean the appliance.
•
Do not use harsh abrasive cleaners or sharp metal scrapers to
•
clean the glass door since they can scratch the surface, which
may result in shattering of the glass.

SAFETY INSTRUCTIONS

INSTALLATION

WARNING! Only a qualified person
must install this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Follow the installation instructions supplied with
the appliance.
• Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
• Do not pull the appliance by the handle.
• Install the appliance in a safe and suitable place
that meets installation requirements.
• The kitchen cabinet and the recess must have
suitable dimensions.
• Keep the minimum distance from other
appliances and units.
• Before mounting the appliance, check if the
oven door opens without restraint.
• Parts of the appliance carry current. Close the
appliance with furniture to prevent touching the
dangerous parts.
• The appliance is equipped with an electric
cooling system. It must be operated with the
electric power supply.
• The built-in unit must meet the stability
requirements of DIN 68930.
Cabinet minimum
height (Cabinet under
the worktop minimum
height)
(720) mm
3