Zanussi ZPCNA4K1 User Manual page 23

Step 3 Close the oven door to the first
opening position (approximate-
ly 45° angle). Hold the door
with one hand on each side
and pull it away from the oven
at an upwards angle. Put the
door with the outer side down
on a soft cloth on a stable sur-
face.
Step 4 Hold the door trim (B) on the
top edge of the door at the
two sides and push inwards to
release the clip seal.
Step 5 Pull the door trim to the front
to remove it.
Step 6 Hold the door glass panels on
their top edge one by one and
pull them up out of the guide.
Step 7 Clean the glass panel with wa-
ter and soap. Dry the glass
panel carefully. Do not clean
the glass panels in the dish-
washer.
Step 8 After cleaning, do the above
steps in the opposite se-
quence.
Step 9 Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the surface of
the door may overheat.
HOW TO REPLACE: LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
45°
2
B
Put a cloth on the bottom of
1
Step 3
the cavity.
23