Table of Contents
Advertisement
Whirlpool UK Appliances Ltd
INSTALLATION INFORMATION
Taken from the Health & Safety and Installation Guide.
The appliance must be handled and installed by two or more persons. Use protective gloves to unpack
and install the appliance.
Installation and repairs must be carried out by a qualified technician, in compliance with the
manufacturer's instructions and local safety regulations. Do not repair or replace any part of the
appliance unless specifically stated in the user manual.
Children should not perform installation operations.
Keep children away during installation. Keep the packaging materials (plastic bags, polystyrene parts,
etc.) out of reach of children, during and after the installation.
After unpacking the appliance, make sure that it has not been damaged during transport. In the event
of problems, contact the dealer or your nearest Aftersales Service.
The appliance must be disconnected from the power supply before any installation operation.
During installation, make sure the appliance does not damage the power cable.
Only activate the appliance when the installation has been completed.
After installation, the bottom of the appliance must no longer be accessible.
Carry out all cabinet cutting works before fitting the appliance in the furniture and carefully remove all
wood chips and sawdust.
To ensure adequate cooling ventilation, it is important that the oven does not come into contact with
the walls of the furniture and that the space between the worktop and the oven is a minimum of 5 mm.
Do not obstruct the minimum gap between the worktop and the upper edge of the oven.
Only remove the oven from its polystyrene foam base at the time of installation.
The kitchen units must be heat resistant to 90°C.
Do not install the appliance behind a decorative door - risk of fire.
ELECTRICAL WARNINGS
For installation to comply with current safety regulations, an omnipolar switch with minimum contact
gap of 3 mm is required and the appliance must be earthed. If the power cable is damaged, replace
with an identical one. The power cable must only be replaced by a qualified technician in compliance
with the manufacturer instruction and current safety regulations.
It must be possible to disconnect the appliance from the power supply by unplugging it if plug is
accessible, or by means of an accessible multi-pole switch installed upstream of the socket in
conformity with national electrical safety standards.
The rating plate is on the front edge of the oven (visible when the door is open).
In case of replacement of power cable, use only following type(s): H05 RR-F 3 x 1.5 mm². If the fitted
plug is not suitable for your socket outlet, contact a qualified technician.
The power cable must be long enough to connect the appliance, once fitted in its housing, to the main
power supply. Do not pull the power supply cable.
Do not use extension leads, multiple sockets or adapters.
Do not operate this appliance if it has a damaged mains cord or plug, if it is not working properly, or if it
has been damaged or dropped. Keep the cord away from hot surfaces.
The electrical components must not be accessible to the user after installation.
Do not touch the appliance with any wet part of the body and do not operate it when barefoot.
Service Manual UK
English
8 of 43
Advertisement
Table of Contents
