Related Manuals for Hotpoint SX 1038L PX S
Summary of Contents for Hotpoint SX 1038L PX S
-
Page 1: Table Of Contents
SX 1038L PX S SX 1038L P S English Operating Instructions OVEN Contents Operating Instructions,1 Warnings,2 Description of the appliance,3 Installation,4 Electrical Connection,5 Start-up and use,6 Modes,7 Precautions and tips,11 Maintenance and care,11 Troubleshooting,14 Afetr Sales Service,15 Guarantee,16... -
Page 2: Warnings
Warnings Before initiating the automatic cleaning cycle: WARNING: The appliance and its • clean the oven door; accessible parts become hot during use. • remove large or coarse food residues Care should be taken to avoid touching from the inside of the oven using a damp heating elements. -
Page 3: Description Of The Appliance
Description of the appliance Overall view 1. POSITION 1 2. POSITION 2 3. POSITION 3 4. POSITION 4 5. POSITION 5 6. GUIDES for the sliding racks 7. DRIPPING PAN 8. GRILL 9. Control panel Control panel 1. MANUAL COOKING MODE Icons 2. -
Page 4: Installation
Installation Ventilation To ensure adequate ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven ! Please keep this instruction booklet in a safe place for so that it rests on two strips of wood, or on a completely future reference. -
Page 5: Electrical Connection
Electrical Connection Unplug the appliance before all operations, even when replacing the oven lamp. Using the appliance without correct earthing is highly The electrical connection to the mains must be made on dangerous. the appliance. The power voltage and frequency are as ! After connecting the appliance to the flexible cable, indicated on the rating plate. -
Page 6: Start-Up And Use
Start-up and use If a blackout occurs, it will be necessary to reset the clock. If the icon flashes on the display, this indicates that the clock has not been set correctly. ! When inserting the shelf Setting the minute minder make sure the backstop is ! The minute minder may be set regardless of whether the at the rear of the cavity (see... -
Page 7: Modes
(for example: a cooking mode has been programmed to durations). To carry out a reset, switch off the oven, then start at 20:30. At 19:30 a blackout occurs. When the power press and hold the button corresponding to the first manual supply is restored, the mode will have to be reprogrammed). -
Page 8: Automatic Cooking Modes
the air throughout the oven. even once cooking has begun. If the value is modified This helps prevent food from burning on the surface and before the programme begins, it is stored in the memory allows the heat to penetrate right into the food. Always and suggested again by the appliance when the programme cook in this mode with the oven door closed (see “Practical is next used. -
Page 9: Practical Cooking Advice
the dough to rise for approximately 1 hour (the dough 2. Then press the button and set the end time using should double in volume). buttons. • Cut the dough into equal sized loaves. 3. Once you have reached the desired end time, press the •... -
Page 10: Cooking Advice Table
Cooking advice table Modes Foods Weight Rack position Preheating Recommended Cooking (in kg) Temperature duration (°C) (minutes) Standard Sliding guide guide Manual rails rails Multilevel* 2 and 4 1 and 3 210-220 20-25 2 and 4 1 and 3 30-35 2 and 4 1 and 3 160-170... -
Page 11: Precautions And Tips
Precautions and tips Disposal • When disposing of packaging material: observe local legislation so that the packaging may be reused. ! This appliance has been designed and manufactured • The European Directive 2002/96/EC on Waste in compliance with international safety standards. The Electrical and Electronic Equipment (WEEE), requires following warnings are provided for safety reasons and that old household electrical appliances must not... -
Page 12: Sliding Rack Kit Assembly
Sliding rack kit assembly • The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do To assemble the sliding not use abrasive products. - Page 13 Automatic cleaning with the FAST CLEAN 3. Press the button to activate the programmed mode. function 4. When the selected time has elapsed, “END” appears on With the FAST CLEAN mode, the internal temperature of the the TEMPERATURE display and a buzzer sounds. oven reaches 500°C.
-
Page 14: Troubleshooting
Troubleshooting Problem Possible cause Solution The appliance has just been Set the clock. The “Clock button” and the connected to the electricity digits on the display flash. mains or there has been a blackou A programmed cooking mode There has been a blackout. Reprogram the cooking mode. -
Page 15: Afetr Sales Service
Afetr Sales Service No one is better placed to care for your Hotpoint appliance during the course of its working life than us – the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in the country offering you access to 400 skilled telephone advisors and 1000 fully qualified engineers on call to ensure you receive fast, reliable, local service. -
Page 16: Guarantee
5 Year Parts Guarantee Hotpoint also offers you a free 5 year parts guarantee. This additional guarantee is conditional on you registering your appliance with us and the parts being fitted by one of our authorised engineers. There will be a charge for our engineer’s time.