Cutting Times; Maintenance/Cleaning; Storage; Disposal, Environmental Protection - Grizzly EHS710-69R Translation Of The Original Instructions For Use

UK
Care of Free-Growing Hedges:
Free-growing hedges are not shaped when
cut, although they must be regularly main-
tained so the hedge does not become too high.

Cutting Times

Deciduous hedges
Hedges of coniferous wood April and August
Evergreen conifer hedges

Maintenance/Cleaning

Repair and servicing work not de-
scribed in this manual should always
be carried by our Service Centre.
Use only original parts.
Pull out the power plug before carry-
ing out any work on the equipment.
Wear gloves while handling the
blades.
Carry out the following maintenance and
cleaning work regularly. This will guarantee
a long and reliable service life.
• Before each use, check the hedge trim-
mer for obvious defects such as loose,
worn or damaged parts. Check the se-
cure seating of the bolts in the cutter bar.
• Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
• Check coverings and safety devices for
damage and correct seating. Replace
these where necessary.
• Keep the ventilation slots and motor
housing of the device clean. Use a
damp cloth or a brush to do this. Do
not wash down the equipment with wa-
ter, or submerge it in water.
• Do not use any cleaning agents or sol-
106 106
June and October
from May
vents. These could cause irreparable
damage to the equipment. Chemical
substances can attack the plastic parts
of the equipment.
• Clean the cutter bar carefully after each
use. Wipe it off with an oily cloth or
spray it with a metal protective spray.

Storage

• Keep the trimmer in the blade guard
supplied, in a dry place and out of
reach of children.
To hang the equipment on the wall
as desired, either directly or with
the blade protection, there are two
holes each on the blade holder
contact protection guard (1) and on
the blade protection (11).
To install, use the two screws and
wall plugs provided.
Disposal,
environmental
protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Do not dispose of electrical appli-
ances in household waste.
• Return the tool to a recycling centre.
The plastic and metal parts used can
be separated and sorted for recycling.
Ask our service centre for details.
• To dispose of the packaging, place the
box with waste paper. Dispose of pla-
stic parts in the dual system.
• We will dispose of your defective
equipment sent in, free of charge.