Operation - Santint MS3 Manual

3） Before operation, remove the air out of each pump. Follow the procedures::
● Press and hold the Rough release button and pull the Rough gauge upwards to a
certain height, ie. 1Y.
● Release the Rough release button back to its original position
● Lift up the plunger handle slowly to its full extent and then press it down gently. Do not
move the valve handle during this process.
● Repeat the same procedures 5-6 times;
● Follow the same procedures for the Fine gauge.
（Figure 6.4）
7.0

Operation

1) Colorant Mixing
 Connect power cord to a wall socket and press the button to initiate
2) Rotating and Locking of Turntable (See Figure 7.1)
 Press the brake handle down to the
 To lock the turntable:
（Figure 6.5）
mixing. To stop mixing, repress the button. Stir 3 times every day, at 10
minutes time intervals (If client has special requirements, the daily stir
frequency and time can be altered accordingly).
horizontal slot.
o Rotate the turntable to the
desired position.
o Release the turntable brake
handle back up to the vertical
slot.
- 8 -
（Figure 7.1）