Replacement - Santint MS3 Manual

04. Properly dispose the mix of cleaner and colorant according to local environmental
regulations.
05. Reinstall the canister on the turntable.
06. Add some cleaner into the canister.
07. Set the Rough gauge to its maximum scale.
08. Put a container right below the nozzle and then operate as dispensing procedures
(6.3).
09. Set the Fine gauge to its maximum scale.
10. Place a container right below the nozzle and then operate as dispensing procedures
(6.3).
11. Repeat steps 7-9 until the canister is clean (the cleaner can be used for 1-3 times.
Yet fresh cleaner is required for the final cleaning).
12. Leave the canister to dry before re-filling with fresh colorant.
10.0

Replacement

Replace Sniff-Back Piston
01. Rotate the valve handle and pull out the nozzle.
02. Rotate the valve handle to its maximum travel and hold.
03. Pull out the sniff-back piston.
04. Install a new sniff-back piston with small O-ring.
05. Reinstall the nozzle.
06. Release the valve handle.
Replace Canister
01. Loosen but do not remove the three screws that fix the canister under the turntable
using the inner hexagon wrench. Rotate the canister clockwise to remove from the
turntable.
02. While installing the new canister, place the three M6 screws at the bottom of the
canister into the larger ends of the three cone-shaped holes in the turntable.
Caution: Must insert the canister crank into the plastic sleeve in the turntable
(see Figure 7.5.1).
03. Rotate the canister anti-clockwise, shift the canister's three screws to the smaller
ends of the cone-shaped holes, and then fix the screws with inner hexagon wrench
from the bottom of the turntable (See figure 6.1).
- 13 -