Frequent Issues And Troubleshooting - Santint MS3 Manual

11.0

Frequent Issues and Troubleshooting

For issues not listed, please contact us.
Troubles
Motor doesn't work
Uneven flow of colorant
from the nozzle during
dispensing.
Canister is loose on
turntable.
Colorant
dispense easily.
Piston doesn't move easily.
Agitator doesn't
during mixing.
Colorant leakage at the
nozzle.
Diagnoses
Power supply
engage.
The fuse is broken.
The wire to the motor is not
connected.
The motor is broken
The belt is loose.
Air bubbles in the cylinder
Colorant in canister is low.
Dried deposits of colorant
causing blocks.
Loose fastening screws.
doesn't
Nozzle blocked.
Colorant
hardened in the canister.
The crank shaft under the
move
canister is not attached to
the plastic sleeve of the
rotating panel.
Worn out O-ring.
does not Check if the Mains Switch is with charge,
the plug is plugged well.
Replace fuse.
Open the top cover plate, reconnect the
Replace motor.
Fasten the belt.
See "Preparation Before Operation ". Allow
the bubbles to escape
Top off colorant.
Clean canister assembly and
parts.
Tighten fastening screws.
Clean nozzle.
Canister and pump should be removed,
has dried and
emptied and cleaned thoroughly. Replenish
with new colorant.
Reinstall the canister.
Replace O-ring.
- 14 -
Troubleshooting
wire.
relevant