Adjustment - Rechner Sensors LevelMaster Adjusting Instructions

ET = Easy Teach Push Button

3. Adjustment

The sensor adjustment is made by means of a pro-
gramming push button. It is under the protection
flap. Open the flap:
Ideally the attached screwdriver is used for pressing
the programming push button.
Attention: Please take care that during the sensitivity adjustment the active area of the sensor
is completely immersed into the product to be detected.
The following adjustments are possible, in sequences:
With full adjustment the full value is determined actively. The respective missing value is automati-
cally determined by the sensor.
Except for the test function, all outputs are inactive
during the programming process.
With release of the EasyTeach button the corre-
sponding mode is selected and the action will be
executed.
Full adjustment
The following options are available:
chart:
ETW = Easy Teach by wire
3. Adjustment
The adjustment is made using the grey EasyTeach
wire (Pin 5).
Factory Reset Test
The LED reflects the state of the outputs.
LED / output function
yellow = A1
green = A2
• Full adjustment
• Initialisation full adjustment
• Factory reset
• Test
The program state that exists at the moment when the
grey teach wire (Pin 5) is disconnected from the supply
voltage is the selected action that will be executed.
9