• Stop using the Ray if the display shows any faults. • Stop using the Ray if it gets very hot. The Ray will get warm during charging, this • is normal. Keep the plug dry and take appropriate care when operating in wet conditions.
CAUTION – Instructions pertaining to a risk of fire or electric shock. Save these important safety instructions. WARNING – Do not use Ray for any other purpose than to charge an electric vehicle. Charging current You should always have good knowledge about the electrical installation before you start charging and make sure the installation handles the load correctly.
(gear-wheel) and the adjust current with the up/down arrows on the screen and end with OK (green check). 5. Insert the Ray into the EV. Charging starts automatically. The display will begin to show a charging graphic. To stop charging To prevent arching and wear on plugs and outlet, the order of removal is important.
Charge Amps AB reserves all rights to this document, as well as the information and illustrations therein. It is strictly forbidden to – in whole or in part – copy, adapt or translate the information without prior written permission from Charge Amps AB.