Attached luggage systems,
such as Topcase
Modifications
ATTENTION
Modifications to the E-
Scooter
Damage to the affected parts,
failure of safety-relevant func-
tions. Damage caused in this
way is not covered by the war-
ranty.
Do not make any
modifications.
Observe checklist
Use the following checklist to
check your E-Scooter at regu-
lar intervals.
Requirement
Before every journey:
Check the charge level of the
high-voltage battery.
Check operation of the brake
system.
Check operation of the lighting
and signal system.
Check tire tread depth (
Check secure hold of Topcase
and luggage.
Requirement
At every tenth recharging
procedure:
Adjust spring preload on the
suspension strut (
Check front brake pad thick-
ness (
85).
Checking rear brake pad thick-
ness (
86).
Checking brake fluid level of
the front wheel brake (
Checking brake fluid level in
rear wheel brake (
Checking coolant level (
Starting
PreRideCheck
After the operating readiness is
switched on, the instrument clus-
91).
ter runs a test on the display as
well as the indicator and warn-
ing lights, known as the "Pre-
Ride-Check". This is comprised
of two phases. The Pre-Ride-
Check is terminated prematurely
if the brake and start button are
pushed.
53).
Phase 1
The universal warning light and
the symbol for the electrical ma-
chine electronics flash red.
The low-fuel warning light flashes
yellow.
88).
Phase 2
89).
The universal warning light and
90).
the symbol for the electrical ma-
chine electronics change from
red to yellow.
7
69
z
Need help?
Do you have a question about the C evolution and is the answer not in the manual?
Questions and answers