Hazard Warning Lights Sys; Tem; Hazard Warning Lights System - BMW C evolution Rider's Manual

The low beams automatically
switch on when the E-Scooter
is operational.
During the day, the daytime run-
ning lights can be switched on
as an alternative to the low-beam
headlight.
High-beam headlight and
headlight flasher
Switch on operating readiness
( 38).
Press switch 1 toward front to
switch on high-beam headlight.
Pull switch 1 toward rear to
actuate headlight flasher.
Parking lights
Operating readiness switched
off ( 39).
Immediately after turning off
the operational readiness, push
button 1 to left and hold it until
parking lights come on.
Switch operational readiness
on and then off again to switch
off parking light.
Hazard warning lights
system
Operate hazard warning
flashers
Switch on operating readiness
( 38).
NOTICE
The hazard warning lights sys-
tem loads the 12V battery. Only
switch the hazard warning lights
system on briefly.
NOTICE
If a turn signal button is pressed
while the operating readiness
is switched on, the turn signal
function will replace the warn-
ing light function the entire time
the turn signal button is pressed.
Once the turn signal button is no
longer being pressed, the warn-
ing light function will resume.
4
41
z