BMW C evolution Rider's Manual page 63

between ­25 °F (­32 °C) and
+104 °F (+40 °C).
Start charging procedure
Operating readiness switched
off ( 39).
The charging procedure
only starts when operating
readiness is switched off.
The charging procedure will
be interrupted if operating
readiness is switched on during
the charging procedure.
Open the left flap.
Remove the charging socket
cover 1.
If necessary, connect the stan-
dard charging cable from the
domestic power outlet or the
Mode3 charging cable from the
charging station. If charging at
a charging station, follow any
instruction at the charging sta-
tion.
The standard charging cable
will automatically carry out all
of the required test steps. If
LED 1 turns green, the test
was successful. If LED 3 turns
red, the test was not success-
ful and the charging procedure
cannot start or the charging
cable cannot be connected to
the vehicle. The following test
steps will be carried out:
The wall outlet will be checked
to see if the wiring is incorrect
A check will be carried out
to see if there is a protective
ground connection
A check will be carried out to
ensure that the prerequisites
for proper charging are in place
The status displays / fault mes-
sages are listed in the chapter
"Technical Data". If fault mes-
sages appear, they can be re-
set as follows:
Separate the standard charging
cable from the voltage sup-
ply by removing the connector
from the wall outlet.
Reinsert the connector after 3
seconds.
Critical faults that indicate dam-
age to the standard charging
cable cannot be reset. These
faults include:
6
61
z