BIXOLON DX Series How To Mount Auto Cutter

KN04-00185A (Ver.1.2)
1. Turn the Power Switch Off at the rear of the Printer.
Power Switch
2. Remove the Cover Roller L&R and press the right side of the Cover STD
in the direction indicated by the yellow arrow to remove it.
You can also remove it by pressing the left side in the same manner.
Cover Roller L&R
Cover STD
3. Insert the Auto Cutter Wire into the Wire Hole.
Auto Cutter Wire
4. Engage the Hooks (red circles) with the square-shaped sockets
(yellow squares) in the order from top to bottom.
Be careful that the Wire does not get stuck.
5. Reassemble the Cover Roller L&R that was removed in step 2.
How to Mount Auto Cutter
Off
Wire Hole
DX/TX(4inch Model) Series
6. Place the bottom of the Printer face the front. Press the Hooks (red circles)
toward the inner side to remove the Cover DIP. Then, shape the Auto Cutter
Wire as shown below.
Be careful to avoid tangling with other wires when shaping.
Cover DIP
For the model SLP-DX42x / TX42x, install the EMI Core into the Auto Cutter Wire
As shown below.
7. Insert the Auto Cutter Wire into the Auto Cutter Connector (red square) in
the correct direction.
8. Reassemble the Cover DIP that was removed in step 6.
Cover DIP
9. In order to operate the Auto Cutter, the settings must be changed through the
utility. Access the Bixolon webpage (www.bixolon.com) and download the
Unified Label Utility.
Connect the communication cable (USB) and Turn the Printer power On.
Then, change the settings in the following order.
Launch 'Unified Label Utility'
'USB' Click!
'Connect' Click!
'OK' Click!
'Configure Printer Setting' Click!
Auto Cutter Wire
EMI Core
Auto Cutter Connector
Peeler Connector
'Advanced' Click!
'Get From Printer' Click!
Media Handling 'Cutter' Setting!
'Set to Printer' Click!
'Close' Click!