Advertisement
Table of Contents
1
Short tube
Holder connector
Long tube
Base connector
3 Insert the long tube into
the base connector then
tighten the screws
using included Allen key
Security Kiosk Dual Stand for 7-14 Inch Tablets
Package Contents
Insert the case connector into
the short tube the tighten the screws
using included Allen key
PAD-UATPB2
Key slot
Base
Stylus
support@ctadigital.com
Fixed clamp
Holder
Holder connector
Lock
Sliding clamp
Key
Tube connector
Insert the tube connector
2
into the long tube then
tighten the screws
using included Allen key
Advertisement
Table of Contents
Related Manuals for CTA PAD-UATPB2
Summary of Contents for CTA PAD-UATPB2
- Page 1 Security Kiosk Dual Stand for 7-14 Inch Tablets PAD-UATPB2 Package Contents Fixed clamp Insert the case connector into the short tube the tighten the screws using included Allen key Holder Short tube Holder connector Lock Sliding clamp Holder connector Long tube...
- Page 2 Using the holder 1) Place the stand on a flat surface and orient the holder vertically, with the fixed end at the bottom and the sliding end on top. 2) Pull back the lock catch at the rear of the holder. Place tablet corner diagonally into the fixed clamp end, then push sliding end down until it is firmly cradling tablet.
Need help?
Do you have a question about the PAD-UATPB2 and is the answer not in the manual?
Questions and answers