Connecting The D-Rgb Led Strip; Testing The Loop - ekwb EK-Quantum Vector Trinity RTX 3080/3090 Active Backplate User Manual

CONNECTING THE D-RGB LED STRIP

TESTING THE LOOP

To ensure the installation of EK components was successful, we
recommend you perform a 24-hour leak test.
When your loop is complete and filled with coolant, connect the
pump to a PSU outside your system. Do not connect power to any
of the other components. Turn on the PSU and let the pump run
continuously.
Inspect all parts of the loop, and in case the coolant leaks, fix the issue
and repeat the testing process. To prevent possible damage, please
ensure that all hardware is dry before the system is powered on.
STEP 1
Plug the 4-pin D-RGB connector from the GPU water block to the
D-RGB Header on your motherboard or controller. The LED strip will
work only if the pin layout on the header is as follows: +5V, Data,
Empty, Ground.
D-RGB HEADER
RGB HEADER
STEP 1
- 12 -
Incorrect installation or installation to a wrong header can
damage the LED strip or the header itself!