Installing Fittings And Tubing - ekwb EK-Quantum Vector Trinity RTX 3080/3090 Active Backplate User Manual

INSTALLING FITTINGS AND TUBING

EK- PLUG
G1/4
TUBING
EK-FITTING
STEP 1
STEP 1
Screw-in two (2) G1/4 threaded male fittings. Attach liquid cooling
tubes and connect the water block to the cooling loop.
Do not forget to plug the remaining two openings with
enclosed EK-Plug G1/4 or its equivalent.
You can use any opening as an inlet/outlet port. The pre-mounted
terminal is positioned for the optimal flow in the EK-Quantum
Vector Trinity RTX 3080/3090 water block and in the EK-Quantum
Vector Trinity RTX 3080/3090 Active Backplate. The terminal can
be shifted for 180 degrees but by using it so, the inlet and outlet
ports are changed.
EK recommends using EK fittings with all EK water blocks.
CAUTION: When using connectors other than EK
fittings, pay special attention to the length of the fittings'
male G1/4" thread – 5mm is the maximum G1/4" thread
length allowed!
- 11 -