Joy Sport CT-Economic Manual page 36

STEP:5
1) Frist, distinguish between the left/right pedal support tube
(note: check pedal 是upport tube with left/right label)
2) Set both pedal support tube (#71&#72) to the main frame
as drawing shown first。
3) Insert long bushing (#79) to the axle on main frame (disc), then
inset both pedal
trube (#71&#72), insert short bushing (#80) washer (#1 7), secure each
with M10 nylon lock nut (#12) fully tighten up
4) cover the nut with end cap (#5)
STEP:6
1) Insert both pre‐assembled connecting tube (#83) to each of swivel
Tube (#66 & #67)
2) locking up both with screws (#18) as drawing shown。
3) Finally, set end cap (#5 )cover the nut.
STEP:7
As photo shown
1) set the swing arm handle bar (#69 & #70) was insertd on the left L /Right R
of the swing arm handlebar .
2) turn the handlebar on the aligned holes , secure both with two screws
(#18) and lock.
3) Finally cover both nuts with end cap (#5)
STEP:8
As photo shown
1) Fit the fixed handlebar (#68) with the screws (#6) and thru the bracket hold
of upright tube with screw drive,
2) Set both EKG grip cables thru the small holes under the fie handlebar (#68)
on the upright tube.
3) Pick up the cables from top of the upright tube.
4) Secure the fix handlebar covers with screws ( #59)
Note! the cover (#84B) got a nut inject in the bar
PEDAL SUPPORT TUBE ASSY（一）
PEDAL SUPPORT TUBE ASSY（二）
UPPER SWING ARM HANDLE BAR
FIXED HANDLE BAR ASSY
NO part list QUANTITY
#5 2
#12 2
#17 2
#79 2
#80 2
NO part list QUANTITY
#18 4
#5 4
NO part list QUANTITY
#18 4
#5 2
NO part list QUANTITY
#6 2
#59 1
#84 1