Advertisement
Available languages
Available languages
STEP:1
FRONT SUPPORT ( Front Stabilizer) ASSY.
As photo shown
1) in order to facilitate assembly, use one of the lager styroform set under the
Frame ( as photo shown)
2) Attach the front support with transportation wheels to the frame with two
bolts (#19) washers (#65) nuts (#20)
3) locking sleeves with tool and cover the nut with two caps (#21)。
STEP:2
As photo shown
1) In order to facilitate assembly, use one of the lager styroform set under the
Frame ( as photo shown)
2) Attach the rear support to the frame with two bolts (#19) washers (#65)
nuts (#20)
3) locking sleeves with tool and cover the nut with two caps (#21)
STEP:3
As photo shown
1) place upright tube on top of a chair ( or by a second person to assist
holding) close to the main frame be facilitated to connect the cables.
2) check the direction of upright tube before connect the Top/Bottom
pre‐assembled cables as photo shown.
3) fixing eight screws (#18) with finger locking first then tighten all firmly.
Note! tighten the two screws on the label "①" screw hold and then
locking up the rest of six screws.
STEP:4
1) Set both pedal tube (R#71/L#72) & plastic pedals(#52/#53) on the floor, indentity
the (R/L) match up left set (#71/#52) & right set (#72/#53).
Note! the pedal has left/right label, check the diredtion of pedl for front and foot
protection edge of pedal as drawing shown)
2) lock up both pedals to the tube plate with screws(#22), nut (#20), with tool socket
& screw driver firmly ( as drawing showm)
Note! three sets of holds on the tube plate, user may choice one set to use,
eash set will give one inch variation pedal distance to select, make sure both
pedasl select the same location of holes
REAR SUPPORT ( Rear Stabilizer) ASSY.
UPRIGHT TUBE ASSY. TO THE FRAME
PEDAL ASSY
NO
part list
QUANTITY
#19
2
#65
2
#20
2
#21
2
NO
part list
QUANTITY
#19
2
#65
2
#20
2
#21
2
NO
part list
QUANTITY
#18
8
NO
part list
QUANTITY
#22
8
#20
8
*
1
*
1
Advertisement
