Casio fx-9750GII User Manual page 334

Message
Time Out •
Circular •
ERROR
Please •
Reconnect
Too Many Data •
Fragmentation •
ERROR
Invalid Name •
Invalid Type •
Storage •
Memory Full
No Card* •
SD Card Full* •
Invalid file •
name or folder
name.*
Invalid Card* •
Card is •
protected*
Data ERROR •
Card ERROR* •
Data is •
protected*
II
* fx-9860G SD only
Meaning
A Solve calculation or integration
calculation was unable to satisfy
convergence conditions.
There is a circular reference
(such as "=A1" in cell A1) in the
spreadsheet.
The connection was dropped for
some reason while updating the
operating system.
The number of data items is too
large.
Memory must be optimized before
any more data can be stored.
The file name you input includes
invalid characters.
An illegal data type is specified.
The storage memory is full.
There is no SD card loaded in the
calculator.
The SD card is full.
Data or folders that are supported
by this calculator cannot be found
on the SD card.
A card that is not compatible with
the calculator is loaded.
The SD card is write protected.
A data error occurred.
An SD card error occurred.
The Read Only attribute of the SD
card loaded in the calculator has
been turned on using a computer,
etc.
Countermeasure
• If you are performing a Solve
calculation, try changing to the
initial default estimated value.
• If you are performing an
integration calculation, try
changing to a larger
• Change cell contents to remove
the circular references.
• Reconnect and try again.
• Delete unneeded data.
• Optimize memory.
• Use the correct characters to
input a valid file name.
• Specify valid data.
• Delete unneeded data.
• Load an SD card.
• Delete unneeded data.
• Replace the card with one that
contains data/folders that are
supported by this calculator.
• Replace the card with a
compatible card.
• Remove write protection.
• Check to make sure you are
writing correct type of data and try
again.
• Remove and correctly insert the
SD card and try again. If this error
occurs again, re-format the SD
card.
• Turn off the SD card's Read Only
attribute.
-4
tol
value.