Table of Contents
Advertisement
5.4 Using a Casket with the
Roller System
1.
Place a stationary bier pin (not supplied) in one of the front bier-
pin holes.
2.
Load the casket onto the roller system and push the casket
against the stationary bier pin.
3.
Place an adjustable bier pin (not supplied) in one of the rear bier-
pin holes (Figure 10). Tighten the adjustable bier pin to secure the
casket on the roller system.
4.
To unload the casket from the vehicle, remove the adjustable bier
pin and roll the casket off the roller system.
5.5 Removing and Replacing the
Roller System in a Vehicle
1.
To remove the roller system from the vehicle, push down and
turn a lock knob 1/4 turn until the lock pin is released from the
mounting plate (Figure 11).
2.
Repeat with the second lock knob.
3.
Lift the roller system out of the vehicle.
4.
To replace the roller system in the vehicle, align a lock pin with the
slot in a mounting plate (Figure 12).
5.
Push the lock knob down to insert the lock pin through the slot.
Turn the lock knob left or right ¼ turn to secure the lock pin in the
mounting plate.
6.
Repeat with the second lock knob.
© Ferno-Washington, Inc. / 234-1845-01 / June 2019
Using the Roller System
Adjustable Bier Pin
10
11
Lock Pin
12
11
Advertisement
Table of Contents
