Table of Contents
Advertisement
5.1 Before Placing the Roller System
In Service
●
Before use, personnel who will work with the roller system must
read and understand this manual. Appropriate skills and training
are also required. See "Operator Focus" on page 5.
Set up the roller system. See "Installation" on page 7.
●
Confirm that the roller system operates properly. See "Inspecting
●
the Roller System" on page 13.
5.2 General Guidelines for Use
The roller system is for professional use only.
●
Use the roller system only as described in this manual.
●
Follow standard mortuary procedures when using the roller system.
●
Improper operation can cause injury. Operate the roller
system only as described in this manual.
Improper securing of the cot or casket can allow it to move
in the vehicle and cause injury. Secure the roller system,
cot and/or casket in the vehicle as described in this manual.
5.3 Using a Mortuary Cot with the
Roller System
1.
Remove the bier pins (not supplied) from the roller system.
2.
Load the mortuary cot into the vehicle and onto the roller system,
following the instructions in the cot users' manual (Figure 7).
3.
Push the cot forward until the cot posts rest in the roller system
post cups (Figure 8).
4.
Hook a restraint over the cot frame and pull the tab to tighten the
restraint (Figure 9).
5.
Repeat with the other restraint.
6.
To unload the cot, loosen the restraint by pulling the buckle up.
Unhook the restraint from the cot frame.
7.
Unload the cot from the vehicle, following the instructions in the
cot users' manual.
10
Using the Roller System
5 - USING THE ROLLER SYSTEM
WARNING
Hook
© Ferno-Washington, Inc. / 234-1845-01 / June 2019
7
Cot Post
Post Cup
Restraint
8
Hook
Buckle
Tab
9
Advertisement
Table of Contents
