Installing The Mounting Plates - Ferno 156 User Manual

4.2 Installing the Mounting Plates

1 - ATTACH THE MOUNTING PLATES TO THE TABLE
1. To attach a mounting plate, turn a lock knob and align the lock pin
with the slot in a mounting plate (Figure 3).
2. Push the lock knob down, inserting the lock pin through the slot.
Turn the lock knob ¼ turn until the mounting plate is attached.
3. Turn the mounting plate to align the holes in the mounting plate
with the holes in the bracket. These holes are used to mark the
location of the screw holes.
4. Repeat with the other mounting plate.
2 - MARK THE MOUNTING POSITION
1. Position one or both roller system(s) on the floor at the desired
location(s), with the long rollers and post cups at the rear of the
vehicle. Load and unload a cot on the roller system, then a casket,
while checking the following (Figure 4):
If two roller systems will be installed, confirm they will not
○
interfere with each other
Confirm the cot and/or casket load easily onto the roller system.
○
If two roller systems will be installed, confirm that cots and/or
caskets can be loaded onto each.
○ Check the vehicle rear door for a lip or other obstruction that could
interfere with loading. If interference is found, contact Ferno for
assistance. See "Ferno Customer Relations" on page 2.
Confirm the rear doors close securely when the roller system(s)
○
are carrying cots and/or caskets.
Confirm that mounting the roller system(s) at the desired
○
locations will not damage or interfere with electrical wiring,
brake lines, the fuel tank, or other vehicle elements.
2. Mark the mounting points on the floor through the mounting
plates.
3. If the vehicle floor is carpeted, use a grease pencil to trace the
edge of the mounting plate on the floor, then cut and remove a
square section of carpeting to allow the mounting plate to sit flat
on the floor.
8
Installation
Lock Knob
Bracket
Mounting Plate
Slot
Drilling through carpet may unravel the carpet. If the floor is
carpeted, use a grease pencil to mark the mounting plate and
mounting locations on the floor. Cut out a square section of
carpet around the mounting plates before drilling.
© Ferno-Washington, Inc. / 234-1845-01 / June 2019
Lock Pin
NOTICE
3
4