3 - INSTALL THE MOUNTING PLATES
Before drilling through the vehicle floor, contact the vehicle
manufacturer for advice on:
avoiding obstructions such as the fuel tank, oxygen lines, etc.
●
●
installing support structure if needed, including backing plate
positioning, material, and thickness.
determining the appropriate length and type of fasteners to secure
●
the mounting plate to the floor of your vehicle.
Ferno recommends you drill a pilot hole through the vehicle floor at
each mounting point (Figure 5) to confirm the mounting holes are at
the expected locations. Then, use an appropriate-size drill bit, fasteners
and/or other tools to install the mounting plates to the floor (Figure 6).
© Ferno-Washington, Inc. / 234-1845-01 / June 2019
Installation
5
6
9