Advertisement
R0E5563NEDMB01
3. Specifications
Table 2 shows the functional specifications of this product.
Table 2
Specifications of This Product
Item No.
Item
1
MCU for use
2
The MCU type name
installed on this product
3
Power supply
4
System clock (EXTAL)
5
Sub clock (XCIN)
Note*: 1. Use this product at a voltage (VCC > V
4. Reset Circuit
Figure 2 shows the reset circuit, with the level on the RES# pin pulled up by a 510-kΩ resistor.
38-pin connector (CN3)
Pin 9 (RES#)
*1
Notes*: 1. The number indicated is the pin number of the 38-pin connector (CN3).
2. The number indicated is the pin number of the YQSOCKET100SDF (IC1).
Figure 2
Reset Circuit
R20UT2221EJ0200 Rev.2.00
Mar 05, 2014
Specification
• RX63N- and RX631-group MCUs in PLQP0100KB-A packages
•R5F563NEDDFC
(ROM: 2 Mbytes, RAM: 128 Kbytes, E2 Data Flash: 32 Kbytes )
• Power (VCC = AVCC0 = VREFH = VCC_USB) at 2.7
from the user system.
• Power (VREFH0) at 2.7 to AVCC0 is supplied from the user system.
• Power (VBATT) at 2.3 to 3.6 V is supplied from the user system.
• The state of power supply can be monitored through the test pins (TP1 for
VREFH0, TP2 for AVCC0, TP3 for VREFH, TP4 for VBATT, TP5 for
VCC_USB, TP6 for VCC, and TP7 for GND).
• 4 to 16 MHz clock signals are supplied from the user system.
• 32.768 kHz clock signals are supplied from the user system.
) that doesn't make the MCU enter the state of power on reset.
POR
R0E5563NEVKZ00
UVCC
MCU (IC1)
R8
510kΩ
R9
0Ω
RES#
User's Manual
*1
to 3.6 V is supplied
R0E55630EPFK20
YQSOCKET100SDF (IC1)
Pin 10 (RES#)
*2
Page 3 of 8
Advertisement
