Brother NV1250D Operation Manual page 195

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Error Message Probable Cause
A pattern is being stored.
The start/stop button or reverse/reinforcement stitch button was pressed
when no pattern is selected.
Bobbin thread has run out.
Little bobbin thread remains.
When the embroidery unit is attached.
You tried to set a number of characters that will not fit within the frame.
The upper thread has become tangled around the bobbin case, and the
needle is bent and hitting the needle plate, etc., so the sewing machine
stops (refer to page 186).
You tried a function that cannot be used when the embroidery unit is
attached.
5
A card that cannot be used with this product has been inserted, and you
tried to select a pattern from the card.
An embroidery pattern incompatible with this machine was selected.
The utility stitch or character stitch key was pressed while the
embroidery unit is attached.
You try to retrieve a pattern downloaded as one for a different machine.
The machine is in embroidery mode and the combined character
pattern is too large for the embroidery frame. You can rotate the pattern
90 degrees and continue combining characters.
The start/stop button, the embroidery key, or the memory key is pressed
in embroidery mode, but the embroidery unit is not attached.
The bobbin winder is winding the bobbin.
Troubleshooting 193