Receiving Problems - Canon JX200 User Manual

Cause
There may be other documents being
sent from memory.
An error may have occurred during
sending.
The telephone line may not be working
properly.
The receiving fax machine may not be
a G3 fax machine.
Documents Sent From the Fax are Spotted or Dirty
Cause
The receiving fax machine may not be
working properly.
The document may not have been
loaded correctly into the Document
Tray.
Cannot Send Using Error Correction Mode (ECM)
Cause
The receiving party's fax machine may
not support ECM.
ECM may be disabled.
Errors Occur Frequently While Sending
Cause
The telephone lines may be in poor
condition, or you may have a bad
connection.

Receiving Problems

Cannot Receive a Document Automatically
Cause
The fax may not be set to receive
automatically.
The fax may have a document stored in
memory.
An error may have occurred during
reception.
The Multi-Purpose Tray may be empty.
The telephone line may not be
connected properly.
56 Troubleshooting
Allow time for those documents to finish sending.
Print an activity report and check for an error (see page 41).
Make sure there is a dial tone when you press [Hook] or when you lift the
Handset. If there is no dial tone, contact your local telephone company.
Make sure the receiving fax machine is compatible with this fax machine (which
is a G3 fax machine).
Check the fax by making a copy (see page 18). If the copy is clear, the problem
may be in the receiving fax machine. If the copy is spotted or dirty, clean the
scanner components (see page 50).
Remove the document, stack it if necessary, and load it into the Document Tray
correctly (see page 16).
If the receiving party's fax machine does not support ECM, then the document is
sent in normal mode without error checking.
Make sure ECM is on (see ECM TX on page 39).
Lower the transmission speed (see TX START SPEED on page 40).
For the fax to receive documents automatically, the receive mode must be set to
<FAX ONLY MODE>, <FAX/TEL AUTO SW> (Fax/Tel mode), DRPD, or
<ANS.MACHINE MODE> (see page 28) must be set . If you have set
<ANS.MACHINE MODE>, check that an answering machine is connected to
the fax and that it is turned on with an outgoing message properly recorded (see
page 30).
Print out any documents stored in memory (see page 34).
Check the LCD for an error message (see page 62).
Print an activity report and check for an error (see page 41).
Make sure paper is loaded in the Multi-Purpose Tray (see the Easy Setup
Instructions).
Make sure all line connections are secure (see the Easy Setup Instructions).
Action
Action
Action
Action
Action